This file for the Authentikit stick provides a base for mounting on the floor. You will need to ensure that the X and Y coords are scaled to 200mm x 200mm and then the Z coords to the height that you wish - make sure you delink the X, Y and Z coords in your slicing software (I use Cura). The “Alternative Spade grip mounting base” is designed to fit in the recess and then you just drill holes for your choice of mountings - I'm using 5.5mm studs bonded in the holes with nuts to secure the stick.
This has been created under a Creative Commons licence for all to use: https://creativecommons.org/licenses/by-nc-sa/4.0/
- 1.24 kB
- 33 Downloads